EXP Computer Portable CD-ROM Manual de usuario

PORTABLE CD-ROMUSER’S MANUALWITH CD-ROM+ CARD

/D is used to set the device name. It can be any name up to 8 characters.This name must be the same as the name you will specify in theMSCDEX.EXE opt

Figure 10After the PCMCIA 32-Bit Card support is installed, Windows will ask you toreboot your computer. Then you should refer to the first section ti

The other procedure is from ‘Control Panel.’ Click on ‘Add/RemovePrograms’ icon, click on the ‘Install’ button then follow the on screeninstructions.

TROUBLE SHOOTINGWindows 95The Windows 95 32-bit mode plug-n-play drivers will automatically allocatethe hardware resources for PORTABLE CD-ROM, theref

Error messages generated by EXPCDG.EXE:v v Error: PCMCIA card is not present!If the above message appears, it means EXPCDI.EXE can't find anyPCMC

PCMCIA(PC CARD) SOFTWARE INFORMATIONIf you have installed the PCMCIA software, such as SystemSoft’s CardSoftor Databook’s Cardtalk, then EXPCDG.EXE wi

The device driver names of the major PCMCIA software are listed below:Software/DeviceDriverSystemSoftCardSoftPhoenix AwardCardwareIBMThinkPadSocket Se

IBM PCMCIA SOFTWARE SAMPLE CONFIG.SYS FILELASTDRIVE=ZDEVICEHIGH=C:\DOS\HIMEN.SYS/TESTMEM:OFF /MACHINE:2DEVICEHIGH=C:\DOS\EMM386.EXE NOEMS X=D000-DFFFB

EXP COMPUTER, INC. EXP MEMORY PRODUCTS.NON-TRANSFERABLE LIMITED WARRANTYEXP COMPUTER INC., AND EXP MEMORY PRODUCTS("EXP") warrants that theP

TRADEMARKSSystemSoft is a registered trademark of SystemSoft Corporation.CardSoft is a trademark of SystemSoft Corporation.Phoenix is a registered tra

INTRODUCTIONThe PORTABLE CD-ROM brings in the latest mobile computing technologyto notebook computer users with portability and convenience. ThePORT

PART NAMES AND FUNCTIONSFRONT PANEL OF THE CD-ROM DRIVE•• Disc Tray:This disc tray is used to insert the compact disc.‚‚ Load/Stop button:• Press this

POWER SOURCEThe PORTABLE CD-ROM can be either powered by the AC adapter or bythe batteries as a flexible option. However, the AC adapter has a priori

REMOVING THE BATTERIES1. Remove the battery lid by sliding the cover in the direction of the arrowas shown in Figure 3.2. Lift up the battery ribbon t

HARDWARE INSTALLATION1. Connect the PCMCIA interface card to the CD-ROM drive. Press firmlyuntil the CD-ROM connector is seated, and tighten the two

SOFTWARE INSTALLATION FOR DOS/WINDOWS 3.1The INSTALL program helps you install the device driver into the computereasily. Please follow the instructi